-40%
Elastomeric 5

Elastomeric 5" Driver Pad for Clarke Super E and V-5 Edgers 53534A .50

$ 17.16

Availability: 100 in stock
  • Restocking Fee: No
  • MPN: 53534A
  • Condition: New
  • Type: Edger
  • Brand: Clarke American
  • Make: Clarke-American
  • Country/Region of Manufacture: United States
  • All returns accepted: Returns Accepted
  • Refund will be given as: Money back or replacement (buyer's choice)
  • Model: Super E
  • Item must be returned within: 30 Days
  • Power Source: Any Voltage
  • Country of Manufacture: United States
  • Return shipping will be paid by: Seller

    Description

    ELASTOMERIC RUBBER 5" PAD DRIVER
    CLARKE PART # 53534A
    FOR CLARKE MODEL SUPER E and V-5 EDGERS
    Instructions for replacing the pad, taken directly from the operator's manual:
    In time the elastomer on the pad may wear or become damaged. To replace, remove pad by placing screwdriver in slot of shaft, grasp pad and rotate shaft counterclockwise. Remove existing elastomer and clean hub throughly to remove old adhesive. Roughen surface of new elastomer to provide good bonding. Apply a good rubber cement to both surfaces and allow to tack. 3M# 1300 rubber and gasket cement is a suitable choice. Apply elastomer to hub and knead throughly. Apply pressure to elastomer and allow to stand over night. Apply a medium strength thread locker to the external threaded end of the shaft. Install belt in grooves on hub and screw down on shaft. Install abrasive retainer on to shaft. Locate a
    fl
    at surface and tape 80 grit abrasive to surface. Using machine "dress in" by sanding the elastomer on the pad. Continue sanding until the entire surface of the elastomer shows signs of sanding. As in
    operation of the machine, take precautions performing this procedure.
    FREE FIRST CLASS SHIPPING in US!